Palisade fencing is supplied piece small and erected on site to easily accommodate different site requirements. The posts we usually use for higher fences for sites that require heightened security. The posts are set at 2.75m centers and either concreted into the ground or can have Base Plates attached for them to be four times bolted to an existing solid base such as a concrete floor or to the side of a brick wall.

Color Power Coated

* Advantage: Pretty appearance

* Using Area: Park, Zoo, Landscaping Department, Villa Area

* Height: 4 feet-10 feet

* Width: 3 feet-10 feet

Hot-dipped Galvanized

* Advantage: Top anti-rust ability

* Using Area: Factory, Power plant, Courtyard, Construction Area, etc.

* Height: 4 feet-10 feet

* Width: 3 feet-10 feet

The palisade fencing pales used are either a D section or a W section and can have rounded and notched top or a triple pointed top for extra security. The thickness of the pales can be adjusted to suit your requirements as well. The D section pale is normally 3.0mm thick and the W section normally 2.0mm thick but can be increased if stronger pales are required.

The rails are generally 50mm x 50mm Angle Bar but can be decreased or increased dependant on the site requirements.

The whole system is securely bolted together using security nuts and bolts. The bolt is designed to fit perfectly with the desired pale section and the nut snaps off to leave a cone attached to the bolt so intruders cannot undo.

The finish of the posts, rails and pales can be supplied and installed in a standard galvanized finish to prevent rust and degradation or can also have a polyester powder coated finish in a colour of your choice.